The transmitter included with your Vapor has been pre-bound for you at the factory. Should you need to re-bind the transmitter and receiver/ESC unit or when using the Vapor's RTF transmitter with another aircraft, please follow the instructions below. Please also note that the instructions you will reference will depend on whether your aircraft and transmitter feature AutoBind or not.
Vapor RTF sets using AutoBind (LED on aircraft receiver/ESC unit and transmitter will blink immediately upon powering on):
1. Ensure flight battery is fully charged and transmitter AA batteries have adequate power.
2. Plug the flight battery into the receiver/ESC unit and the LED will begin blinking.
3. Within 5 seconds of powering on the Vapor receiver/ESC, power on the Vapor RTF transmitter (LED on the transmitter will begin blinking) and the bind process will complete within 15 seconds.
Vapor RTF sets without AutoBind (LED on receiver/ESC unit will begin blinking after 5 seconds of being powered on. LED on transmitter remains solid when powered on):
1. Ensure flight battery is fully charged and transmitter AA batteries have adequate power.
2. Plug the flight battery into the receiver/ESC unit. The LED on the receiver/ESC unit will begin blinking after 5 seconds.
3. Once the LED on the receiver/ESC unit is blinking, push IN on the left control stick while powering on the transmitter. Release the left stick once the transmitter is powered on. The transmitter will beep, signifying the transmitter is in bind mode. The bind process will complete within 15 seconds.
